EEVblog Electronics Community Forum
Products => Test Equipment => Topic started by: slbender on August 14, 2018, 09:24:05 pm
-
This B&K 2190 is a ~100 Mhz. 2 Channel Analog Oscilloscope that has been gathering dust for several years - due to a shorted NEC Dual Fet (unobtainium) near the input on one channel. Also lots of bad soldering that likely caused the failure... Any suggestions on the part, the soldering I can repair.
Thanks,
Steven
-
What's the part number?
-
What's the part number?
NEC UPA71A Dual Jfet N Channel
-Steven
-
You can try UT-Source, I've bought in the past from them some dual j-fets and were ok (I've checked them also with a curve tracer in order to be sure it is the real stuff).