Products > Test Equipment
BM869S not reading correct voltage
joeqsmith:
--- Quote from: Fungus on July 22, 2024, 01:20:17 pm ---
--- Quote from: J-R on July 22, 2024, 09:54:00 am ---Maybe this is a flash memory issue and some calibration points were lost.
--- End quote ---
On two meters simultaneously?
--- End quote ---
Possible, once details about the alignment were made public, it does seem the kiddies like to try and run through them using what ever they have laying around as a standard. And we have seen people who feel they need to have two meters reading identical to the last place.
J-R:
The BM869s and other Brymen DMMs obviously have a small amount of flash of some kind for the calibration data as well as the mode memory. If there was a manufacturing defect of some sort the data stored there could degrade over time.
Navigation
[0] Message Index
[*] Previous page
Go to full version