| Products > Test Equipment |
| Bricked Siglent SDG 1032X |
| << < (4/5) > >> |
| Joe1vm:
Hello, I have the same experience with the transfer of waveform between the scope 1104X-E and SDG 1032X. Exactly the same issue happened to me about 2 months ago, when I tested my new SDG 1032X with the last available firmware 1.01.01.33R3. Fortunately, If I remember well, I was able to overcome the EEPROM: failed(), FPGA: failed(), ds2301: failed() screen by getting to standard menu and set the "Power on" to default. It seems, that the generator try to use broken waveform from the incomplete transfer during power on causing the error message. When the power on was set to default, the generator recovered after restart. |
| Omega Glory:
That's good to know! Since then have you been able to successfully transfer waveforms from the scope to the generator? I've seen a few videos of people doing so captures with a ton of points (2.8Mps), which then appear to be automatically reduced to fit the generator. But those videos are older, so I'm wondering if there was a firmware change and now that capability is broken. |
| Joe1vm:
Unfortunately not. Threfore I gave it up. |
| Omega Glory:
All right, tomorrow I will do some experiments to see if reverting to an earlier firmware version will fix things. Hopefully I won't brick things for good... One thing that isn't clear is if it's due to the scope's firmware or the generator's firmware, however I suspect it is the latter, because the CSV file format is pretty simple. |
| Omega Glory:
--- Quote from: tautech on January 26, 2024, 03:42:47 am ---Or select a smaller memory depth in the scope before capture and saving then transferring to arb the smaller capture. --- End quote --- Just tried that. Captured a waveform with 14kpts, transferred it to the scope which converts it without issue, however the resultant waveform is a ramp instead of a sine wave, so something's not right. |
| Navigation |
| Message Index |
| Next page |
| Previous page |