Products > Test Equipment

Brymen BM 235 Startup issues

<< < (3/8) > >>

wraper:
Sounds more like problem with rotary switch.

NoisyBoy:
I would guess the meter is defective.  I have yet seen any electronics not accepting rechargeable batteries, that is assuming your rechargeables are freshly charged.

derree:
Hello everybody,

The meter works perfectly with the alkalines, and starts to produce the mentioned behaviour when used with the eneloops. I am thinking that the eneloops start to fail after one year of usage. Time to get some new rechargeables!

Specmaster:
Thanks for letting us all know, I know that I have never had much success with rechargeable batteries of any make, as mentioned earlier, they seem to struggle to deliver peak currents when required.

wraper:

--- Quote from: Specmaster on January 02, 2020, 08:48:00 pm ---I have never had much success with rechargeable batteries of any make, as mentioned earlier, they seem to struggle to deliver peak currents when required.

--- End quote ---
Nonsense. NiMH have several times lower internal resistance than alkaline and thus can deal with much higher loads. Look at that graph above in my post. Try drawing a few amps from alkaline. At 1A they are virtually useless, even at 0.5 A they still suck a lot.

Typical alkaline discharge curve.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod