Products > Test Equipment
Brymen BM 235 Startup issues
<< < (6/8) > >>
wraper:

--- Quote from: derree on January 03, 2020, 05:28:46 am ---Hi,

I already tried that, pressing some of the buttons during startup with both, alkalines and eneloops. Same result: 2 times of 10, the meter with eneloops is stuck in the boot process, with alkalines the meter pulls through every single time.

I have to correct myself, the eneloops are older than a year, it was my second batch bought in September 2017, so we are talking about 2 years now. My fault!

--- End quote ---
Attach to lab PSU instead and try switching it on with different voltages. In any case, hanging on startup is failure. If batteries provide too low voltage, it still should not hang on power on.
Specmaster:

--- Quote from: wraper on January 03, 2020, 10:44:23 am ---
--- Quote from: Specmaster on January 03, 2020, 10:36:05 am ---2 or 3 times and then not used for while fail next time they are charged with error codes on the battery charger

--- End quote ---
Sounds like your charger is (probably faulty) crap. It's your charger what fails, not batteries  :palm:.

--- End quote ---
Not really, because I have a number of different chargers, and is the SAME batteries that fail each time with any of the chargers.
wraper:

--- Quote from: Specmaster on January 03, 2020, 10:50:04 am ---Not really, because I have a number of different chargers, and is the SAME batteries that fail each time with any of the chargers.

--- End quote ---
Unless you bought some extraordinary crappy batteries, this sounds really strange.
Ohm:
https://www.eevblog.com/forum/testgear/fluke-289-meter/ Somehow my name got change from dab147315 but this was my first post and change all my meters over to lithium batteries and no problem with that Fluke 289 to this point.
paulbt:
Hi, everyone !

I recently bought a Brymen 235 and while I was playing around with it, I was curious if it has any power-on options like Flukes. The only thing that I found was while holding "HOLD" button when turning on - it displayed "9". The manual does not mention anything about this. Does anybody knows what it means?
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod