Products > Test Equipment
Brymen BM789
groovesonshunt:
I just got my new Brymen BM789 today, and I am very pleased with the build quality.
The first thing that I did noticed was, that the meter moves a lot when it's on the stand while I use the dial.
Can anyone tell me if your 789 has a rubber ring around the edge of the stand?
Mine came with the 789011 firmware, and when I look at the picture on the .eu website, there seem to be a rubber ring around the edge of the stand.
What about your 789.....does it have a non-slip coating?
J-R:
Nothing on mine. I don't see anything in any photos either.
You could probably find a small bit of rubber hose, split it open and attach it to the stand.
Fungus:
--- Quote from: groovesonshunt on January 16, 2023, 06:20:51 pm ---The first thing that I did noticed was, that the meter moves a lot when it's on the stand while I use the dial.
--- End quote ---
All meters do that. :-//
Neutrion:
Also nothing on mine.
BillyO:
Nothing on my 786 (same form factor) either.
I use a non-slip anti-static mat on my bench. As such it (nor any other meter) does not move when I use it on the stand.
Don't see anythjing in the picture either. This shot is from Brymen's EU site.
Navigation
[0] Message Index
[#] Next page
Go to full version