Products > Test Equipment
Brymen BM789
Antrus:
Do you mean the capacitance is the internal capacitance of the multimeter? Since only the resistor is measured. This happens only in auto-range mode when measuring from several kilo-ohms.
Grandchuck:
I meant capacitance in the circuit under test. I have no other suggestions.
supertrabuco:
Hello, the kings of the east have visited me and have left me an EEVBlog BM786.
Greetings and happy new year to all the electronic family ; :-DMM :D
Caliaxy:
--- Quote from: Antrus on January 04, 2022, 06:53:57 pm ---Greetings to all. I have a question about measuring resistance with this multimeter. At first it shows a slightly lower value, after a second the final one. Is it so for everyone? Firmware 78908.In reviews, he showed the value immediately.
--- End quote ---
Mine does pretty much the same thing - it shows an intermediary value (pretty close to the final one) after about a second and a final stable value after about another second (tried to measure a 2k2 resistor in auto-range). I wouldn't worry too much about this, just be patient and keep in mind that the first value shown is not the final one.
Many low cost meters do exactly the same (also tried Uni-T UT61e). BM235 doesn't, it shows directly a final value and so does Fluke 87V (which also measures about 25% faster than BM789).
BM789 is a very accurate (and great for its price) meter, but not exactly a joy to use. Still a nice one.
Antrus:
It would be better if he did not show this intermediate value. I am sure that the firmware can fix this.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version