| Products > Test Equipment |
| Brymen BM789 |
| << < (59/81) > >> |
| Neutrion:
Did you manage to update the FW, or you have different meters? BTW did the dc offset sinewave overload indication on the mV scale issue changed with any of the FWs? There was a debate whether it would be possible at all to solve that with any FW update. |
| Monkeh:
--- Quote from: Neutrion on August 05, 2022, 08:41:54 pm ---Did you manage to update the FW, or you have different meters? --- End quote --- Only dealers have the programming tool and access to the firmware images, so it seems rather unlikely he updated it. |
| joeqsmith:
Assuming you are addressing me, I talked about the firmware updates throughout the videos for both the 786/9 meters. As for DC biased waveforms, again, I supplied all that detail in the videos. There was a bit of a discussion here (more than once) where a few beginners were asking about DC biased waveforms and I dove into it a bit further for them. That's all online here. |
| Neutrion:
Sorry, I was actually adressing Antrus, but something went wrong it seems. But as long I remember you also have the 08. Antrus seems to have tried two never versions. |
| Antrus:
I have firmware 8. The person on YouTube has firmware 10. Of course, I haven't updated anything. The multimeter is almost 2 years old, but the manufacturer has not yet noticed such an obvious error in the firmware. Perhaps this resistance range is not needed by anyone. |
| Navigation |
| Message Index |
| Next page |
| Previous page |