Products > Test Equipment

Brymen BM789

<< < (77/81) > >>

floobydust:
If it's not a mechanical problem, it might be the old F/W has a problem with the act of selecting manual range (mode) when the auto-ranging it hasn't yet settled or it converged at the seam, and then it appears to reboot?

joeqsmith:
If that's true, he could have tried a 100 and 1k or so to move it away from that switch point but still give roughly the same settling time.     

c0d3z3r0:

--- Quote from: joeqsmith on September 25, 2022, 03:10:13 pm ---If that's true, he could have tried a 100 and 1k or so to move it away from that switch point but still give roughly the same settling time.   

--- End quote ---

I already said that this doesn't happen for other values. I don't have to prove everything with a video, though.

c0d3z3r0:
@joeqsmith Regarding that second issue (jumping value), your BM789 with 78908 shows the same behaviour. Just look at your own video ;)
https://youtu.be/siPjGNL6U0E?t=92
The dmm first shows 0.6358k, then after a second switches to 0.6998k.
This is gone with 78911 later in that video.

armandine2:

--- Quote from: c0d3z3r0 on September 25, 2022, 10:26:52 pm --- I don't have to prove everything with a video, though.

--- End quote ---

The video is a representation of what has happened, presumably - as you yourself have just demonstrated with your analysis of Joe's video.

or am I missing something :-\

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod