Products > Test Equipment

Brymen BM829s beep volume

(1/4) > >>

Toolio:
Hi, i am new to this forum but i have a question that i couldn't find answered anywhere on the internet.
Perhaps i am the only one that has this question. There seems to be no better place than to ask it here so here it goes:

Is there a way to change the beep volume on my Brymen 829s multimeter?

I just bought it and it seems to be a very good multimeter but one thing that annoys me from the start is this very loud beep that you get to hear a lot with this meter. There is a way to temporarily turn it off but i don't mind the beep, just i wish it wasn't so loud.

I couldn't find a service manual anywhere but my hope is that there must be a potmeter in there somewhere that can lower the beep volume.

I hope i can turn this great multimeter into an awesome multimeter.

Fungus:
You can open it up and insert a small sock into the speaker.  :popcorn:

Kean:
Assuming that model has a typical round beeper (like BM235), you can just place some tape over the hole

Toolio:
Hey that sounds like a good solution :clap:
Where would this speaker be located and how can i recognize it?

Here is a photo of the inside but i don't recognize a speaker.
Do i need to remove that print? Or is it on there?

Kean:
Appears to be on the other side of the PCB between terminals BZ+ and BZ- (just to the left of the main IC)

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod