Products > Test Equipment
Brymen BM867s ???
<< < (4/17) > >>
Fungus:

--- Quote from: rsjsouza on May 04, 2021, 09:25:19 am ---Unless you are working with audio and is interested in measuring the upper echelons of the frequency band, it should be alright.

--- End quote ---

That's what oscilloscopes are for.  :)
rsjsouza:

--- Quote from: Fungus on May 04, 2021, 10:07:12 am ---
--- Quote from: rsjsouza on May 04, 2021, 09:25:19 am ---Unless you are working with audio and is interested in measuring the upper echelons of the frequency band, it should be alright.

--- End quote ---

That's what oscilloscopes are for.  :)

--- End quote ---
But not as accurate.
nubinstanley:

--- Quote from: Specmaster on May 03, 2021, 03:46:53 pm ---Yeah, get the 867s, you will not be disappointed if you do, the switching between continuity and resistance is not that much of an issue, and in any case you could always use the UNI-T for the continuity to avoid that small issue of the n$ range.

--- End quote ---

 :-+
nubinstanley:

--- Quote from: Fungus on May 03, 2021, 06:58:12 pm ---
--- Quote from: Specmaster on May 03, 2021, 03:46:53 pm ---Yeah, get the 867s, you will not be disappointed if you do, the switching between continuity and resistance is not that much of an issue, and in any case you could always use the UNI-T for the continuity to avoid that small issue of the n$ range.

--- End quote ---

That particular Brymen isn't too bad with the function overloading.

eg. The meters with temperature will usually combine capacitance/diode together so that's another small annoyance. More features = more overloading, so it goes...

--- End quote ---

The BM867s has single channel temp measurement right ? Hopefully, it comes with one temp probe ? ???
nubinstanley:

--- Quote from: rsjsouza on May 04, 2021, 09:25:19 am ---@nubinstanley, as others have confirmed, your choice for the BM867S  is good and its other limitations w.r.t. to your original BM869S choice are the temperature and the lower bandwidth (20kHz instead of 100kHz for the 869). Unless you are working with audio and is interested in measuring the upper echelons of the frequency band, it should be alright.

Regarding probes, many threads in this forum praise Probe Master for its quality and features - even Dave made a video about it a long time ago. Just one aspect if you care for aesthetics: check the thread below for information about the banana jacks that may not be fully inserted depending on the model purchased.

https://www.eevblog.com/forum/testgear/probe-master-test-leads/

Good luck in your purchase!

--- End quote ---

Thank you for the input  :-+

ANd, I have already asked this question, but lemme repeat. :D The 867s supports single channel temp measurement ? So, it should come with one temp probe ?
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod