Products > Test Equipment

Brymen BM867s ???

<< < (16/17) > >>

Fungus:

--- Quote from: miro123 on September 16, 2022, 10:17:34 am ---Thanks everyone who help me clarify my next purchase.
I'm power electronics/software developer.
The most signals that I measure are distorted, with higher harmonics and even worse, the pwm signals are still visible somehow. That is mostly true during development phase. The final product is good .

--- End quote ---

Sounds like a job for an oscilloscope, not a multimeter.

miro123:

--- Quote from: 2N3055 on September 16, 2022, 11:17:13 am ---
What are you trying to measure exactly? Is DMM right tool for that?

--- End quote ---
Hard to answer this question. The list is endless.
It is pretty much everything for what I have done the last 20 years with Fluke 187/189 in the lab and Fluke 87 in the field.

I have BM869s for 3 years. I would say that I start to trust on this meter.


EEVblog:

--- Quote from: Fungus on September 16, 2022, 02:25:01 pm ---
--- Quote from: miro123 on September 16, 2022, 10:17:34 am ---Thanks everyone who help me clarify my next purchase.
I'm power electronics/software developer.
The most signals that I measure are distorted, with higher harmonics and even worse, the pwm signals are still visible somehow. That is mostly true during development phase. The final product is good .

--- End quote ---

Sounds like a job for an oscilloscope, not a multimeter.

--- End quote ---

Yeah, sounds more liek a job for a portable scope like one of the Micsig's or a Fluke Scopemeter

charonme:
my BM867s came with probes that now measure around 12 ohms and fluctuate wildly. I tried various other probes, even crocodile ones and they were all even much worse except the two set of probes that came with my cheap uni-t clamp ammeter (stab and crocodile), they both show around 0.2 ohms

J-R:

--- Quote from: charonme on October 17, 2023, 04:24:32 pm ---my BM867s came with probes that now measure around 12 ohms and fluctuate wildly. I tried various other probes, even crocodile ones and they were all even much worse except the two set of probes that came with my cheap uni-t clamp ammeter (stab and crocodile), they both show around 0.2 ohms

--- End quote ---

Can you post a photo showing this situation and the leads?

Regardless, test leads are going to be considered a disposable item, so if the internal wires are broken or they have some other damage, then just buy some replacements.  The official Brymen silicone leads are only about $10USD.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod