Products > Test Equipment
Brymen BM869(867) alternative software.
nour:
Cable connection schematic, diagram, circuit, anything !!
joeqsmith:
--- Quote from: Sairus on October 01, 2016, 10:39:21 pm ---people ask: can we get source code?
I ask: do you run it and you want change something?
they say: no we will not run unknown executable share code we will analyse it.
--- End quote ---
If it was not clear, I would want the source or just documentation in order to write a library for their adapter to support LabVIEW.
--- Quote from: Sairus on October 01, 2016, 10:39:21 pm ---OK do you have IDE,do you have skills to analyse and will you spend your time for analysis?
--- End quote ---
This is why I felt a document detailing the interface would be best. I had been using the free tools from MS but this last go around I converted everything to native LabVIEW. Again, I have not looked into it at all. I did not purchase the OEM interface because the lack of LabVIEW support. A standalone application would typically be of little value to me as normally when I collect data it is just part of a bigger test.
If you wanted to support LabVIEW with a closed source, well documented library, that would be great!
Sairus:
--- Quote ---Cable connection schematic, diagram, circuit, anything !!
--- End quote ---
--- Quote ---This is why I felt a document detailing the interface would be best.
--- End quote ---
Here some useful information.
https://www.dropbox.com/s/jzyh571ened24df/ENG.pdf?dl=0
joeqsmith:
--- Quote from: Sairus on October 03, 2016, 03:51:55 pm ---
--- Quote ---This is why I felt a document detailing the interface would be best.
--- End quote ---
Here some useful information.
https://www.dropbox.com/s/jzyh571ened24df/ENG.pdf?dl=0
--- End quote ---
Thanks! That doc was just what I was after.
Did you do the conversion from the LCD to ASCII in the PIC or is it just being used to handle the serial communications with the meter? Just curious if you are doing the conversion in your software.
JackM:
--- Quote from: joeqsmith on October 03, 2016, 11:45:44 pm ---Did you do the conversion from the LCD to ASCII in the PIC or is it just being used to handle the serial communications with the meter? Just curious if you are doing the conversion in your software.
--- End quote ---
I'm pretty sure that's done in the PC software side. The PIC likely just sends the raw data packets over serial comms, then it gets decoded on the PC side according to Brymen's protocol.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version