Products > Test Equipment
Brymen BM869(867) alternative software.
coromonadalix:
very good work
thks Sairus for creating this piece of software, i would love to have one ported for the Fluke 189 series, to replace the Fluke View software, and i would give some $$ to support the creator
t1d:
Thank you, so much, Sairus, for your hard work, time, talent and graciousness, in sharing your Brymen program. I think I missed this post, back when we were working on the original "sniffing" thread... Doh! I have downloaded the file and look forward to trying it out.
spidola:
Thank you Sairus :)
Stefan3v:
Sairus this project is a joke? Because is not funny!
I tried version Sairus DMM 1.04 with Arduino LEONARDO and it does not work. Pullup resistors for IR receiver: 5K, 10K, 20K, 30K, 40K, 50K, 60K, 100K, 150K.
Option "Port debug line" not work in version 1.04. |O
Sairus:
I checked software using virtual port pair and port debug line work fine. It show data after receiving and clear line after some time to indicate port activity. If after enabling function you dont se anything it mean that there no data coming to the port.
So do you select right port and settings set?
Do you connect to it without errors?
Error message (no signal) aper on display?
Arduino sketch was tested on UNO model, first i recommend send random data to serial port to check software and windows serial driver on you PC.
Best regards Sairus.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version