Products > Test Equipment

Brymen IR connection protocol - Anyone sniffed it yet?

<< < (10/31) > >>

Simon Loell:
Hi Jancelot.

The best chance is propably with Jadew. I haven't looked into the project since sniffing the protocol. And my primary whish is to be able to log both temperature channels, so my motivation isn't that high.
maybe next winther I'll be writing a Visual Studio program just for the practice.

-Simon

bfishman:
This is digging up an old post, but I'm also curious if either of you gentlemen continued your efforts on this project?

Simon Loell:
Hi bfishman.

I haven't worked further on the project.
All hardware issues are solved, so the only part missing is coding a program for a PC. I would sigges c# in Visual Studio, since it is a common language and Visual Studio is free.

-Simon

jancelot:
Hi Simon Loell, is the complete documentation available on the internet or is just a work of yours?

Simon Loell:
I haven't searched the internet, but all information should be available for you in this thread.

A short brush up:
Segment info:  #15   https://www.eevblog.com/forum/testgear/brymen-ir-connection-protocol-anyone-sniffed-it-yet/15/
Schematic info: #18 picture1 https://www.eevblog.com/forum/testgear/brymen-ir-connection-protocol-anyone-sniffed-it-yet/15/] [url]https://www.eevblog.com/forum/testgear/brymen-ir-connection-protocol-anyone-sniffed-it-yet/15/[/url]
Protocol info:  #34  https://www.eevblog.com/forum/testgear/brymen-ir-connection-protocol-anyone-sniffed-it-yet/30/

-Simon

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod