| Products > Test Equipment |
| BSIDE ESR02 Pro Transistor Tester (teardown & quick test) |
| << < (4/14) > >> |
| 001:
--- Quote from: indman on September 22, 2018, 08:39:46 am ---I have collected an firmware only for the Karl-Heinz 1.13k version. I think that there are no obstacles to use the version 1.33m Markus. :) --- End quote --- What did You mean? Is factory firmware for BSIDE so old? |
| indman:
The Chinese firmware of BSideESR02 is based on the version 1.11k Karl-Heinz! It is already quite outdated firmware which has no new opportunities of the version 1.13k. |
| 001:
--- Quote from: indman on September 22, 2018, 08:52:27 am ---The Chinese firmware of BSideESR02 is based on the version 1.11k Karl-Heinz! --- End quote --- Sorry Is BSideESR02 is ONE chineese version housed in fabric-made enclosure? |
| precaud:
--- Quote from: indman on September 22, 2018, 07:37:01 am ---BSideESR02 has no protection of measuring ports! If you have connected the capacity which had a charge, then the processor it is necessary to replace with new. :) --- End quote --- Yes, I always discharge capacitors before testing. But I wasn't testing capacitors last time it was used - I was sorting thru a box of pulled transistors, separating FETs from BPs. It's quicker than looking up the numbers :) So this failure is unexpected. |
| indman:
--- Quote from: 001 on September 22, 2018, 09:57:53 am ---Sorry Is BSideESR02 is ONE chineese version housed in fabric-made enclosure? --- End quote --- This clone can have the name chineese version DTU-1701. They are identical on an firmware and a hardware stuffing. :) --- Quote from: precaud on September 22, 2018, 12:12:45 pm ---Yes, I always discharge capacitors before testing. But I wasn't testing capacitors last time it was used - I was sorting thru a box of pulled transistors, separating FETs from BPs. It's quicker than looking up the numbers :) So this failure is unexpected. --- End quote --- I don't find any serious obstacles not to manage to repair this device. The scheme is rather simple in understanding if to study a detailed manual from dear Karl-Heinz. :) |
| Navigation |
| Message Index |
| Next page |
| Previous page |