Products > Test Equipment

BSIDE ESR02 Pro Transistor Tester (teardown & quick test)

<< < (4/14) > >>

001:

--- Quote from: indman on September 22, 2018, 08:39:46 am ---I have collected an firmware only for the Karl-Heinz 1.13k version. I think that there are no obstacles to use the version 1.33m Markus.  :)

--- End quote ---

What did You mean? Is factory firmware for BSIDE so old?

indman:
The Chinese firmware of BSideESR02 is based on the version 1.11k  Karl-Heinz!
It is already quite outdated firmware which has no new opportunities of the version 1.13k.

001:

--- Quote from: indman on September 22, 2018, 08:52:27 am ---The Chinese firmware of BSideESR02 is based on the version 1.11k  Karl-Heinz!

--- End quote ---

Sorry
Is BSideESR02 is ONE chineese version housed in fabric-made enclosure?

precaud:

--- Quote from: indman on September 22, 2018, 07:37:01 am ---BSideESR02 has no protection of measuring ports! If you have connected the capacity which had a charge, then the processor it is necessary to replace with new. :)
--- End quote ---

Yes, I always discharge capacitors before testing. But I wasn't testing capacitors last time it was used - I was sorting thru a box of pulled transistors,  separating FETs from BPs. It's quicker than looking up the numbers  :)  So this failure is unexpected.

indman:

--- Quote from: 001 on September 22, 2018, 09:57:53 am ---Sorry
Is BSideESR02 is ONE chineese version housed in fabric-made enclosure?

--- End quote ---
This clone can have the name chineese version DTU-1701. They are identical on an firmware and a hardware stuffing. :)


--- Quote from: precaud on September 22, 2018, 12:12:45 pm ---Yes, I always discharge capacitors before testing. But I wasn't testing capacitors last time it was used - I was sorting thru a box of pulled transistors,  separating FETs from BPs. It's quicker than looking up the numbers  :)  So this failure is unexpected.

--- End quote ---
I don't find any serious obstacles not to manage to repair this device. The scheme is rather simple in understanding if to study a detailed manual from dear Karl-Heinz. :)

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod