| Products > Test Equipment |
| BSIDE ESR02 Pro Transistor Tester (teardown & quick test) |
| << < (9/14) > >> |
| tppc:
Hi there, My ESR02 is the version with ALL ISP signals on J6. I could connect the TL866 with no problems. I then wanted to backup the old firmware but Lock Bits are programmed, so it reads only FFs. I spent a few hours reading this Looooong thread https://www.eevblog.com/forum/testgear/$20-lcr-esr-transistor-checker-project/ but at the end, I was not able to find a link to a firmware that would fit in my BSIDE ESR02. Can anyone help me finding the correct firmware and where to download it from? I found this link https://www.mikrocontroller.net/svnbrowser/transistortester/Software/trunk/ but then I am lost :-// Regards. |
| tppc:
Hi there, I finally found this post where Per Hasson attached a backup of his meter firmware 1.11k. --- Quote from: Per Hansson on December 28, 2017, 12:32:20 pm ---Yes of course, here you go. Just one caveat to be aware of: it contains the calibration data from my meter. So you should make a new calibration even though you will have no message telling you it's not calibrated.... And the fuses where set according to the picture included. --- End quote --- Atmega replaced and programmed In circuit with my TL866. Tester recovered. 8) Special Thanks to Per Hansson and all contributors. :-+ P.S. If someone knows how to identify an updated firmware that would fit this tester, please post a link Thank you |
| 001:
--- Quote from: tppc on January 09, 2020, 10:03:03 pm ---Atmega replaced and programmed In circuit with my TL866. --- End quote --- That is pinout for that? Thanx |
| Brad808:
I'd be willing the buy a preprogrammed microcontroller chip if someone can mail me one. I too fried one of mine on a charged cap. I've since bought a new unit for component testing and now use an esr70 for testing caps since it will auto discharge for me... But since I'm a hoarder I didn't throw out the old unit I just tossed it on the shelf haha. I wouldn't mind spending a few minutes with hot air replacing the micro and getting the other one running again. |
| tppc:
--- Quote from: 001 on January 10, 2020, 02:59:26 pm --- --- Quote from: tppc on January 09, 2020, 10:03:03 pm ---Atmega replaced and programmed In circuit with my TL866. --- End quote --- That is pinout for that? Thanx --- End quote --- Hi there, there are 2 versions of the PCB. For my version, the pinout is there https://www.eevblog.com/forum/testgear/$20-lcr-esr-transistor-checker-project/msg2698438/#msg2698438 From Top to Bottom : V+, Gnd, Reset, SCLK, MISO, MOSI For the other version, not all signals are available from J6, as shown there https://www.eevblog.com/forum/testgear/bside-esr02-pro-transistor-tester-(teardown-quick-test)/msg1868543/#msg1868543 Regards |
| Navigation |
| Message Index |
| Next page |
| Previous page |