Products > Test Equipment
BSIDE ESR02 Pro Transistor Tester (teardown & quick test)
<< < (10/14) > >>
glicos:
I have he same problem with my beside esr02. Following programming direction here, and use the firmware posted here by Per Hansson i have below problem:
Is my atmega 328p chip need to be replaced?? It suddenly stopped working..Thanks for the possible inputs..
precaud:
Last year I jokingly told 001 that the ESR02 screen turns white and the unit stops working.

Well mine is now doing that. Last time used, I was sorting some FETs, not measuring charged capacitors.

Does this mean the 328 chip is fried?
alelo:
this might be an obvious question but.... how am i supposed to connect probe 1, 2 and 3 toghether if my probes have only two leads???
I suppose the calibration process is to remove probes influence on next mesurements so i can't see the point to short the three probes from the smd connection pads ...... anybody can tell me how to calibrate this thing?
tppc:
Hi there,
well, I did use a 3rd probe (same lenght and gauge) and just shorted them all.

Regards
xikamo:
Firmwares for BSIDE ESR02 Pro and other TT https://yadi.sk/d/yW8xa5NJgUo5z
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod