Products > Test Equipment

BSIDE ESR02 Pro Transistor Tester (teardown & quick test)

<< < (10/14) > >>

glicos:
I have he same problem with my beside esr02. Following programming direction here, and use the firmware posted here by Per Hansson i have below problem:
Is my atmega 328p chip need to be replaced?? It suddenly stopped working..Thanks for the possible inputs..

precaud:
Last year I jokingly told 001 that the ESR02 screen turns white and the unit stops working.

Well mine is now doing that. Last time used, I was sorting some FETs, not measuring charged capacitors.

Does this mean the 328 chip is fried?

alelo:
this might be an obvious question but.... how am i supposed to connect probe 1, 2 and 3 toghether if my probes have only two leads???
I suppose the calibration process is to remove probes influence on next mesurements so i can't see the point to short the three probes from the smd connection pads ...... anybody can tell me how to calibrate this thing?

tppc:
Hi there,
well, I did use a 3rd probe (same lenght and gauge) and just shorted them all.

Regards

xikamo:
Firmwares for BSIDE ESR02 Pro and other TT https://yadi.sk/d/yW8xa5NJgUo5z

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod