Products > Test Equipment
BSIDE ESR02 Pro Transistor Tester (teardown & quick test)
XerXes777:
Come from Germany. I would also like to buy the BSIDE ESR02 PRO. Do you have a recommendation where I should buy the device? If it is necessary I would also like to flash the device. Have never flashed an AVR. What do I need for this? Are there more hardware versions of this device? Which I must consider when flashing?
madires:
You'll need an AVR ISP programmer, e.g. a USBasp, and a PC (there are ton's of guides/videos on how to program an AVR). AFAIK, the BSIDE ESR02 PRO comes in two colors (red or black case) and you can get it at your preferred shopping platform.
XerXes777:
I have received a BSIDE ESR02 PRO. With a different hardware version.
Which version can I flash there?
Where are the ports to flash? In the middle?
Which port is what?
Is there a ready compiled version for this board and which is also the latest?
Can I also measure a wire (eg coax cable) inductive or capacitive with this meter?
madires:
You can program k or m-firmware via ISP (J6, needs a simple adapter). For the pinout please see https://disk.yandex.ru/d/yW8xa5NJgUo5z/BSideESR02(DTU-1701)/Schematic%20diagram/DTU-1701_V3.1.JPG. AFAIK, there's no current ready-to-use k-firmware available, and m-firmware needs to be customized and compiled anyway. Low inductance values (<10µH) can be measured by k-firmware's SamplingADC.
XerXes777:
I'm sorry, but I don't understand which firmware is from whom.
m-firmware -> Markus Frejek
k-firmware -> Karl-Heinz Kübbeler
m and k-firmware modified -> https://github.com/madires/Transistortester-Warehouse
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version