Products > Test Equipment
Brymen BM869 - measurement of DCV linearity
<< < (4/4)
J-R:
My BM869s was similarly a bit out when I received it a couple years ago from Welectron.  I ran through a DC calibration/adjustment and it's still pretty much spot on, assuming I reproduce the calibration/adjustment conditions exactly.

Because of that, I find the BM869s to be slightly annoying sometimes.  Temperature and time from power-on can cause it to swing high and low, I would say typically about 5 counts at the top of the range in 50,000 count mode (post calibration/adjustment).

Probably we are unreasonable and asking too much of this handheld...
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod