Products > Test Equipment
Brymen BM869 - measurement of DCV linearity
J-R:
My BM869s was similarly a bit out when I received it a couple years ago from Welectron. I ran through a DC calibration/adjustment and it's still pretty much spot on, assuming I reproduce the calibration/adjustment conditions exactly.
Because of that, I find the BM869s to be slightly annoying sometimes. Temperature and time from power-on can cause it to swing high and low, I would say typically about 5 counts at the top of the range in 50,000 count mode (post calibration/adjustment).
Probably we are unreasonable and asking too much of this handheld...
Navigation
[0] Message Index
[*] Previous page
Go to full version