Products > Test Equipment
Calibration Password for Martel Calibrator
(1/1)
Chance92:
I've recently bought a used Martel MC-1010 calibrator. The output appears to be out of spec, so I'm planning to make some adjustment. However, the calibration menu is password protected. I wonder if anyone know what the password is? The PCB has a marking of "MC1200", so I suppose the password may be the same as the MC-1200 series.
alm:
I've never heard of Martel before, but with other manufacturers things like 0000 or the model number are common default password. Do you know how many characters the password is? Did you try a bunch of the obvious ones?
Chance92:

--- Quote from: alm on September 23, 2022, 11:51:07 pm ---I've never heard of Martel before, but with other manufacturers things like 0000 or the model number are common default password. Do you know how many characters the password is? Did you try a bunch of the obvious ones?

--- End quote ---

I think they were acquired by Fluke back in 2012. They were probably involved in the development of some of the Fluke's handheld calibrators. I believe the password is 3 or 4 digit long. I have tried the common ones but no luck so far. I'm also trying to write a script to run every possible combination through it.
Chance92:
The script worked! The password is 900. Use CR as terminator.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod