| Products > Test Equipment |
| calibration/adjustment procedure for CEM DT-9939 /EXtech EX540 /Digitech QM1575 |
| (1/1) |
| MacGyver0606:
Hi, I'm looking for the calibration/adjustment procedure for any of these Multimeters, which are pretty much the same. I couldn't find it anywhere. Any help?? CEM DT-9939/DT-9929 (original manufacturer) EXtech EX540/EX530 (Americas/Europe) Digitech/Jaycar QM1575 (Australia) Hikari HM2920/2900 (Brazil) |
| threephase:
You can usually get calibration procedures for Extech instruments from Extech support, takes them a couple of days to respond:- http://www.extech.com/support/faq 5th question down the page |
| danilnik:
Good day. You have successfully obtained the calibration procedure for the DT-9969. If it's not difficult, please share) |
| Navigation |
| Message Index |