Products > Test Equipment

calibration/adjustment procedure for CEM DT-9939 /EXtech EX540 /Digitech QM1575

(1/1)

MacGyver0606:
Hi, I'm looking for the calibration/adjustment procedure for any of these Multimeters, which are pretty much the same. I couldn't find it anywhere. Any help??

CEM DT-9939/DT-9929 (original manufacturer)
EXtech EX540/EX530 (Americas/Europe)
Digitech/Jaycar QM1575 (Australia)
Hikari HM2920/2900 (Brazil)

threephase:
You can usually get calibration procedures for Extech instruments from Extech support, takes them a couple of days to respond:-

http://www.extech.com/support/faq

5th question down the page

danilnik:
Good day.  You have successfully obtained the calibration procedure for the DT-9969.  If it's not difficult, please share)

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod