EEVblog Electronics Community Forum
Products => Test Equipment => Topic started by: BeBuLamar on May 21, 2022, 11:10:39 am
-
I have a Fluke 175 which is still working fine but the integrated holster is torn and peeled off. Do you think the I can replace the holster without spending too much money? Well I just want to make it nice if I can without spending too much. I have more DMM than I need.
-
I couldn't see a way to do this on my old 179. You could try to buy and entire back enclosure...
eBay auction: #144556844265
-
Nah, the molded-on rubber can't be replaced separately. You have a buy a whole new case.
-
OK Thanks. The set of front and back cover cost over $100 on Ebay. So I decided to strip all the rubber away and use the meter naked.
-
how cleanly did the rubber come away? i'd me interested in seeing a photo or two of what the meter looks like now :-+
cheers,
rob :-)
-
Not very clean. I hope I will be able to remove it all later.