Products > Test Equipment
Capturing a bunch of CAN-frames, where one might be missing - (SDS800X)
<< < (5/6) > >>
nctnico:
Keep in mind that most DSOs need a minimum oversampling rate. If the CAN rate is reasonably high, 5Ms/s may not allow decoding of the data. The first step is to determine the minimum samplerate at which the CAN messages are decoded reliably. Emphasis on reliably; I've seen DSOs attempt to decode but fail in a subtile way without warning; you end up with data which is garbage.
Martin72:
Yepp, can confirm this behaviour, it makes sense too.

@eTobey:


--- Quote ---The horizontal axis.
--- End quote ---

The way you might think it is not possible at first, which makes sense.
The number of frames is limited to 2000, which can be seen clearly at 2s/div, and even more clearly at 5s/div.
What you can do, however, is zoom in and scroll the section back and forth accordingly.


eTobey:

--- Quote from: Martin72 on March 24, 2024, 10:10:53 pm ---What you can do, however, is zoom in and scroll the section back and forth accordingly.

--- End quote ---

I did not say zoom... Take the first picture, and then move the trigger/scroll, so that decode frames will drop of to the left.
electronics hobbyist:
Your question is difficult to understand. You should take two comparison pictures instead of letting others try to understand your meaning."scroll" should be a horizontal position or trigger delay.
bobxyz:
The MCP2515 is a very common hobbyist CAN-to-SPI chip.  If you can program and are familiar with the Arduino environment, you could use a $20 CAN+Processor board, e.g. https://www.adafruit.com/product/5724, to decode the CAN stream live and generate a trigger for your oscilloscope.  This would let you zoom in on the analog waveforms.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod