Products > Test Equipment
CMS52 Rohde Schwarz external reference
(1/1)
ct2iok:
I have a CMS52 device, and I wanted to link an external reference of 10MHz, this device has no input on the back panel to inject this reference, where can I connect this 10MHz reference and what level (dBm) should I put

The equipment has 3 vertical lines on the display, does anyone know how to fix this?
Best Regards
CJay:
Plenty of clues about where to connect an external reference in the service manual here:

http://eww.ko4bb.com/manuals/81.141.36.151/Rohde_Schwarz_CMS_52_Radiocommunication_Service_Monitor_Service_Manual.pdf

As for the LCD, good luck, it may be as simple as cleaning up a zebra strip but I doubt it on a panel that size.
ct2iok:
Thank you very much, I appreciate your contribution

After taking a quick look at the service manual, I find an indication on page 342 and 369 referring to the X501 which is indicated as a reference, but I don't know if it will also be input, or just output.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod