Products > Test Equipment
CMU200
(1/1)
elettronica52:
My cmu200 has the failed rf signal generator. The test loop of the inputs fails and also the fm deviation. Everything else works. It gives me no faulty module. I measured the signal at 13.8 Mhz in input rxtx is 20 mV. And there are the various modulations. I measured the output of the sma tx and there is only noise with a very low signal, of a few microV. I sent a 10 Mhz signal to the frontend module and it appears at the output.
Has anyone repaired this rxtx module?
IZ2GGS
markus_jlrb:
Dear OM IZ2GGS,

take a look at MC-Forum
    https://www.mikrocontroller.net/topic/433164#new
Some experts for R&S device issues are available there.

Good luck
Markus
snickers:
Some experiments with built in FMR6 (i815 chipset) Ethernet adapter.
Success!
markus_jlrb:
How you load the  C:\NET\NET.CFG during boot?
Via Autoexec.bat?

Markus
snickers:
I loaded via autoexec.bat file manager Volkov Commander (clone of Norton Commander) and then with the help of it did anyting I want.
Generaly, you do not need to do any chages in autoexec.bat. In the original application you can press Alt-F4 and exit to DOS prompt and do anything you need.

Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod