Products > Test Equipment
Confusing resistor package size choices in Fluke 289
Kean:
--- Quote from: gamalot on October 04, 2024, 07:53:34 am ---It's hard to tell what model Fluke used, but I guess most straight mounted 1mm pitch FPC connectors should be suitable as a replacement.
--- End quote ---
Measuring the pitch should be easy - almost certainly 1.0mm, but 0.5mm is common too.
Then find a 20-pin vertical SMD FFC/FPC connector that fits in the space. Check the FPC contact orientation (top/bottom) and the SMD pins alternate sides.
A starting point
https://www.digikey.com/en/products/filter/ffc-fpc-flat-flexible-connectors/ffc-fpc-flat-flexible-connector-assemblies/399
Then narrow down by pitch, mounting type, number of positions, etc, and look at some of the pics and datasheets.
Based on a quick glance, Molex 0528082070 or 0528082071 look like possible options.
mpeters3:
:clap: :clap: :clap: :) :) :) Hey Thank You!!! Gamalot, Coromonadalix, and Kean, for the assistance and education. Wow, you guys are genius status in my book. Thanks for the help. Gives me hope of the repairs being able if I can get the right microscope and tools to do it justice.
Thanks again. I'll be back. And it's not an Arnold reference.
Mpeters3 ;D :-DMM
Navigation
[0] Message Index
[*] Previous page
Go to full version