Products > Test Equipment
Conversion of 500MHz TDS744A to 1GHz TDS784A
<< < (22/24) > >>
madao:
2 ch and 1 Ghz exists, but only color display model. It is called as  TDS782.   (Firmware 5.2e support also  TDS782C. )

I have a   TDS724C aquisition board as good spare part, but i wouldn't try, it is not worth.

Galen:
Thanks Matt.  I may try it someday.  but not now.
olle:
Since I just noted that one of the (TDS754/784/...) acquisition board resistor configurations sets the scope to be a TDS794 (2 GHz BW on 1 channel), I wonder if anyone has tried that one out, and if so - did it work or brick the unit?

---
Real programmers: cat > a.out
Jay_Diddy_B:
Olle and the group,

Welcome to the forum!!

I have just been checking the specification of the TDS794x family, The 794 is 50 \$\Omega\$ only, which means it, (almost certainly) has different input section to the other 700 series family.

I have not seen the inside of the 794 so I don't know for certain.

Regards,
Jay_Diddy_B
olle:
Thanks a lot for that piece of enlightenment. It means that I'll stay with my 754C-to-784C conversion for now.

 :D

Real programmers: cat > a.out
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod