Products > Test Equipment
Conversion of 500MHz TDS744A to 1GHz TDS784A
<< < (19/24) > >>
radioguy123:
I was just wondering if it is possible to convert a 500mhz TDS540C into a 1Ghz TDS580C ? Just wondering if anyone has researched this ?
Thanks for any info on this.
Jay_Diddy_B:

--- Quote from: radioguy123 on November 12, 2019, 02:00:28 pm ---I was just wondering if it is possible to convert a 500mhz TDS540C into a 1Ghz TDS580C ? Just wondering if anyone has researched this ?
Thanks for any info on this.

--- End quote ---

Do you have a TDS540C?

If you do, open the case carefully remove the acquisition board and look for configuration resistors. They will probably be on the back of the board.

If you don't try searching the internet for photographs of the A10 acquisition board.


Regards,

Jay_Diddy_B
radioguy123:
Yes I do have a TDS540C
So it's the A10 acquisition board that you change ?
I will get the scope open and look at the back of the board.
I have read through this thread and I know you have to remove some capacitors also.
Not to mention the re-cal.
I'll get you the board number in a little bit.
I was just wondering if anyone has tried this.
Thanks for the reply.
The A11 board is: 679-4002-00
The A10 board is: 679-4204-00
Alfons:
Please read the thread. You find there, what to look for. On the bottom of the acquisition board are resistors, four pieces. How exactly your equipment must look to change something, I do not know. With my board, it was only necessary to remove one resistor.
madao:
I think, it is possible.



I have collected list of  A10 & A11 Board part numbers.
TDS540C has same A10 board as by  TDS754C.

TDS540C is just a  TDS754C with monochrome CRT and not 13 & 2F options as standard.

regards
matt

Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod