One more I overlooked last time.
You could update the screenshot of the RDFlasher on page 9 to the new and nicer v1.1
Thanks, taken into account. New version will be published soon.
The New version is now available.
See signature or initial post for link.
Another Update
For Firmware 1e
See signature or initial post for link.
Another Update
For Firmware 1f
See signature or initial post for link.
And another update to version 1g
See signature or initial post for link.
Your latest document changes do not seem to be accompanied by the date change for corrections on the bottom of the first page shown. It still states "Latest Document Change: Feb 14, 2021".
Is that correct
Sorry, that should read 2022 instead of 2021.
@sunkmail: I updated the source doc.
Hi! What about a firmware for RD6024 please? Thx.
Hi Everyone,
The document has been updated!
New features, as per the latest "h" firmware.
THANKS Sunkmail (and Dougg and Bateau020) for the reference!!! It's very valuable! And thanks again to UniSoft for all the work.
Just revived this to thank UniSoft. Awesome work.
Also thanks for the manual, Sunkmail. Great job.
Would be great to have a step by step, comprehensive calibration section. Currently, only an example is shown.
bummer the 6024 isnt on the list.
bummer the 6024 isnt on the list.
Of course not on the list, because I do not have it.
Hi Sunkmail. First, thank you so much for creating your excellent manual.
I hope you don't mind I mirrored your manual to Git, so it is easier for people to find and receive updates.
https://github.com/wildekek/rdtech-firmware-unisoftI 'm contemplating the idea of converting the doc to a Git Wiki, so it is easier to maintain. Would you be up for that?
I created an integration with ESPHome and Home Assistant for the RD6006 and I wanted to make it easy for people to find the software and docs.
https://github.com/wildekek/rdtech-esphome
Hi Wildekek,
I don't don't mind mirroring the document at all - The more the better.
I think we've gotten the manual mature enough that I'm comfortable with the idea of opening up the maintenance.
I honestly haven't used github for anything close to it's full potential.
I'm Happy to announce the
Manual has been updated to the newest firmware released earlier today (or yesterday, depending on your timezone
)
Special thanks to bateau020 for being on top of this!
Nitpick:
On page 4 in the Introduction paragraph. It says:
Ruideng has done a good job of documenting their power supplies and postscript files can be
found at this url (note: http rather than https)
That URL has PDF files, not postscript. As I said, it's a nitpick, but there is a difference. I expect most people will be more familiar with PDF.