EEVblog Electronics Community Forum

Products => Test Equipment => Topic started by: geggi1 on September 28, 2021, 04:33:39 pm

Title: Data format in Fluke View 2 software.
Post by: geggi1 on September 28, 2021, 04:33:39 pm

Is there anybody that is familiar with this software?
I have done some measurements on a VFD and would like to use some vertical markers on the Y axes to get an idea about values above a certain voltage.
My project is to troubleshoot a VFD that in the past has killed two motors. The motors are expensive and custom builds about 450kW at 690V 60Hz.
My client is considering replacing the VFD because they are old (+20 years)

Is there anybody that know some software that will accept a data export form the Fluke View2 software and that will give me more options for markers, math and filters?
 
 

Title: Re: Data format in Fluke View 2 software.
Post by: bdunham7 on September 28, 2021, 04:55:16 pm

I have a few versions of Fluke View, but I've no idea what the '2' is.  What test instrument are you using?

Title: Re: Data format in Fluke View 2 software.
Post by: geggi1 on September 28, 2021, 05:13:53 pm

IM using the 190-504 II. I beleve this is the latest model

Title: Re: Data format in Fluke View 2 software.
Post by: bdunham7 on September 28, 2021, 05:38:46 pm

OK, I see the '2' now.  I'm not familiar with that version and haven't used that scope.  But isn't the file from the scope simply stored in a .csv format that can be opened in Excel?

Title: Re: Data format in Fluke View 2 software.
Post by: asis on September 29, 2021, 08:36:56 am

Hi,
Check out the screenshots.
Fluke View2 lets you create reports using cursor measurements.
The data block in the upper right is very informative.
Also, it is possible to analyze the results made and saved by SW of an earlier version of Fluke View ver 4.4 (Scope Fluke199x).
You will need to register your device on the website to receive a key to SW Fluke View2.