EEVblog Electronics Community Forum
Products => Test Equipment => Topic started by: andz on February 28, 2019, 10:29:44 pm
-
I recently bought a new oscilloscope from rigol specifically DS1054Z. Everything is working fine expect detent rotary encoders (for setting scale for vertical and horizontal axes) which skips every second time. I have to do two "clicks" in the same direction to move once. Or if I am "clicking" back and forth nothing happens. Do you have experience with something like that? Thanks for yours answers.
-
Check out the latest firmware that has been released two days ago. From the release notes it incorporates an encoder fix.
-
Thank you for answer, can you link me for that specific update which fixes it. Latest I found was v00.04.04.03.05 from 2018/04/28.
-
I finally found it here: http://www.rigol.com/Support/SoftDownload/3 (http://www.rigol.com/Support/SoftDownload/3)
Thank you very much again!
-
This latest firmware Version 04040402 solves the problem. Vertical gain, TB et al all work properly now. :)