Products > Test Equipment

DG4000 - a firmware investigation

<< < (40/96) > >>

hacker27:
I just noticed a problem upgrading to the non-existing DG4202: LXI does not work anymore. If you want to use LXI, stay with the DG4162, this works well.

cybernet:
LXI works fine, for me.
if u mean the ultra sigma crap tool u have to hack the config files i doesnt know about a non existent model of course

Gandalf_Sr:
I've just ordered a DG4062.  I paln to try the upgrade to 4162 or higher.  Questions:

1. Is Clayton's online compile (bottom of P7 of this thread) to generate an upgrade .cen file still valid?
2. If I have vn 3.0 firmware, do I need to downgrade to 2.0 first?
3. Will the 4062 upgrade to 300 MHz? If so, what is the target model number?

Any guidance much appreciated.

Gandalf_Sr:

--- Quote from: Teneyes on August 03, 2014, 08:38:57 pm ---@ Gandalf
What are you talking about?    Check rigol. site for FW and models
Are you buying a DSO or a Function gen.  .

--- End quote ---
Erm... just having a senior moment, I'm talking about an AWG, the DG4062 but I am mixing my refs to firmware versions up with the DS2072 that I just ordered too.  But I guess the question is, does it matter what firmware version mine is (when it gets here) if I'm thinking of upgrading the AWG?

Gandalf_Sr:
That was easy, just followed the instructions at the bottom of page 7.

I was concerned that my Ser# started DG4E1xxxxxxxx and that there was a strncmp or something that would block that but all I found in code were comments.

Parameters DG4062 DG4202 DG4E1xxxxxxxxx worked, extracted the cen file, and it was accepted no issues.  I can dial up 200 MHz sine waves but haven't actually scoped em.

How do I get to see the Sw Vn, all I see is 00.01.07

Will look at the cal stuff over the weekend.

 :-+

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod