| Products > Test Equipment |
| DG4000 - a firmware investigation |
| << < (77/96) > >> |
| RoGeorge:
No. It should be --- Code: ---cengen.exe DG4062 DG4202 DG4Exxxxxxxxxx --- End code --- where you replace 'DG4Exxxxxxxxxx' with the the serial of your generator, the one deleted with red in the attached photo above. Then, copy on the pen drive the generated license.CEN (check the date and time to see it's the one just created) and read the file with the DG4000 generator. |
| Vahoo:
I and do, I should change the regional languagе? |
| Vahoo:
Dear RoGeorge , "read the file with the DG4000 generator" or update generator? (press HELP and torn ON generator, to insert USB storage ... ) , thanks! |
| RoGeorge:
No. Open DG4000 normally. Do not press Help. Insert USB with file license.CEN into DG4000. Read file "license.CEN" (upgrade generator). Get DG4202. If you see DG4202, finally upgrade firmware to 1.14. |
| PA0PBZ:
--- Quote from: RoGeorge on December 29, 2019, 06:00:04 pm ---Read file "license.CEN" (upgrade generator). --- End quote --- To clarify "Read file": - Press the Store button - If the USB drive was recognized you will see C: and D: under Disk - Turn the Knob to select D: - Press the "File Type" soft button - Press the "All File" soft button - Press the "Browser" soft button - Turn the Knob to select the licence file (only necessary if there are more files on the USB drive) - Press the "Read" soft button - Enjoy |
| Navigation |
| Message Index |
| Next page |
| Previous page |