| Products > Test Equipment |
| DG4000 - a firmware investigation |
| << < (78/96) > >> |
| Vahoo:
Thank you very much, I got everything. :-+ :-+ :-+ |
| zitt:
--- Quote from: TurboTom on December 20, 2019, 12:50:05 am ---zitt - did you check the level accuracy of your DG4000 after the "liberation"? I found mine to be spot on up to 200MHz (DS4102 from Q4/2015). Maybe yours also doesn't need to be calibrated at all. --- End quote --- No. I haven't done anything more than view the output with my Scope. IIRC; mine had some signal attenuation above the 60MHz limit; but, I haven't done anything specific to verify. Again; quick check using aglent scope. --- Quote from: TurboTom on December 20, 2019, 12:50:05 am ---P.s. If you haven't got a spectrum analyzer or a calibrated level meter, you may DIY a detector type level tester with a 50R terminator resistor (preferably 2*100R 1% 805 in parallel), a small signal, low capacitance schottky diode, a 10n smoothing capacitor and maybe a 10k load resistor, coupled to a multimeter. All this has to be assembled just a the back of a BNC connector to keep the impedance low. This "bodge" should give you a good idea of your generator's level accuracy. --- End quote --- I do have a Spectrum Analyzer (CMU200); but was a fleabay purchase so it's calibration isn't assured. The document I have: "CalibrationProcedure.pdf" doesn't appear to discuss calibration or measurement by Spectrum Analyzer. Do you have a link to this "bodge" schematic and/or wiki? |
| EV:
I read this license.gen to my DG4162. It looks to work as earlier but the signal is about 1.4 dBm low at 200 MHz. Between 1 - 160 MHz signal is ok. Is it possible to correct this by calibration? |
| stuartmp:
Hi All, I would like to update my Bootloader & Firmware, Attached is my current system information for my DG4062. I managed to find the necessary files to update it as the current version is 00.01.07 and it says online that I need minimum 00.01.08 to run the current file but I can't find the instructions to Flash the bootloader or Firmware. I'm not interested in Hacking my machine I just want to up date it to the latest version. Could someone please send through some instruction on how to Flash the bootloader and Firmware. I have also attached an image of my current system information. Kind Regards Stuart |
| stuartmp:
--- Quote from: PeDre on February 13, 2020, 06:36:32 am ---Here is my firmware collection. The instructions for updating are included. --- Code: ---http://peter.dreisiebner.at/tmp/rigol_dg4000_firmware.7z --- End code --- Peter --- End quote --- Thanks Peter, Just what I was looking for |
| Navigation |
| Message Index |
| Next page |
| Previous page |