Products > Test Equipment
DHO900: can not enable wifi
(1/2) > >>
Basilisvirus:
I try to make my Rigol924S connect to the WiFi using usb wifi adapter and a keyboard.
I have managed to connect the oscilloscope to the wifi at the past, but now that I removed and plugged the wifi adapter again, I cannot.

The issue is, when I open up the android interface, I cannot enable the wifi. It looks like its always disabled. If I click on "on/off" on the wifi signal it very quickly turns on/off, the moment I press it. It wont stay on.



How can I enable the wifi again?
norbert.kiszka:
Did You try to turn it off and on again? Really, that works in this case. This is Android, not an normal Linux distro :/ So best idea will be to use USB hub and have wifi card/adapter/dongle connected all the time.
Basilisvirus:
I tried that. And I just tried it again.
USB of the wifi dongle and keyboard get recognised as the oscilloscope powers up but no difference on the wifi, its still disabled, I cannot enable it.
norbert.kiszka:
In the scope app it will be always visible as disabled. You need to use Android settings. Also check lsmod if module is loaded automatically - If not, Your exact card most likely will not work.

Rigol promised to comply with GPL licence, byt they didn't (I tried to e-mail them many times - no answer). So You can't compile other modules (drivers). For wifi cards we have binary only and only one module. That's the reason I want to say bye bye to the Rigol products.
Basilisvirus:
I will see what I can do and how can I run commands on there...

The Wifi as far as I know should not show "disabled" state by default. See picture below, taken from this youtube video:




Another solution would be to reset the android os, if this can be done, I see there is a system reset option in the android settings, dont know what happens if I click that.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod