Products > Test Equipment
Disappointment with the Ersa i-con Pico soldering station (more DIY editing)
CharlotteSwiss:
Looking carefully at the thread of the heating element, in fact the first crests of the thread are 'worn out'. This is why the nut thread wasn't gripping. It has been ruined since I was struggling to reach this thread with the nut. If it had been metallic, this wouldn't have happened! (first image).
In the second image I highlighted the final click that the tip must make to allow the nut to screw on well. I always screwed with the tip in the right position.
In the second image you can also see the marks I made on the tips when I drilled them (bench vice) :palm:
Happy New Year to all ;)
Navigation
[0] Message Index
[*] Previous page
Go to full version