Products > Test Equipment
DISK CLONING - for one oscilloscope
(1/6) > >>
bozidarms:
Hi,
i cloned a hard drive with Acronis, all went well.
The only problem is, that the partitions letters were L, M and K, instead of C,D and E.
I could change all letters, but not C.
How to create a new partition with the letter C?
tv84:

--- Quote from: bozidarms on January 22, 2023, 03:00:13 pm ---Hi,
i cloned a hard drive with Acronis, all went well.
The only problem is, that the partitions letters were L, M and K, instead of C,D and E.
I could change all letters, but not C.
How to create a new partition with the letter C?

--- End quote ---

 :wtf: This is a Test Equipment forum, right?
bozidarms:
Right - and that disk is from one oscilloscope.
One spare disk, from HDD to SSD.

By the way, you are very polite and your comment is splendid, please continue!
Fungus:
Have tried it to see if it works?
bozidarms:
I have, but SSD was not recognized in BIOS.
I assume that new SSD must have the same C and D named partitions.
Boot part originally is on C partition.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod