Products > Test Equipment

DIY Logic Analyzer Probe and Pods for Siglent (and LeCroy) scopes

<< < (31/51) > >>

oz2cpu:
thanks for getting back to us all Alex,
it is super nice to hear how real work experience turn out to be.
we are a few who have seen the data trig issues, i2c, serial and spi, all is with a few minor bugs in the scope,
if you look for the bug found and suggestion thread, siglent monitor it,
I hope they will fix the reported issues soon, and release a new fw.

TheDefpom:
Thank you all for the work on this DIY LA module.

I have almost finished building one, I had to make some changes to the scope connector shells to allow more room for wiring inside it, I am using coaxial ribbon cables salvaged from a Tektronix LA pod.

I put my version of the scope connector shells up on my thingiverse here: https://www.thingiverse.com/thing:4964027

I have been recording footage to do a video about it for my youtube channel, which I expect to publish either this week or next week.

I haven't actually tried using it yet, once I get the shells all finished and it is built, then I will do some testing of it with all 16 channels, but the electrical tests I have done so far on the cables all look good so I don't know why it wouldn't work.

oz2cpu:
looks great, thanks for sharing.
I add your thingiverse link, to post 1
so we have it all collected one place.

oz2cpu:
my first audio dubbed video, darn that took forever to make :-)

i got my hands on a Siglent LA SPL2016 probe set, and could finally test it side by side with my own DIY
https://youtu.be/paKK0c-4pgw

TheDefpom:
Here is my logic probe build video:


Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod