Products > Test Equipment

DIY Logic Analyzer Probe and Pods for Siglent (and LeCroy) scopes

<< < (38/51) > >>

gtube:
I was thinking, instead of twisting and soldering those interconnect wires between POD and PLUG IN PCBs,  how about use CAT8 shielded Ethernet cable which already has 4 twisted pairs inside? Just install two RJ45 ethernet jacks on both PCBs.

oz2cpu:
the POD files are in the link
try to look at this file
Production_Data_SDS_1.zip

nall:
Thanks to oz2cpu and others for this design. I finished building my set last night and it seems to be working great!

I have extra PCBs if anyone wants them for cost of shipping -- just PM me. all gone

Coder69:
Hi,

I have started to check the Gerber-files for the plugin board. I think the board thickness should be
1.6mm and the surface finish ENIG. Especially for ENIG you can choose the gold thickness between
1 U" and 2 U". What do you you recommend ? Is 1 U" enough ?
BTW: Thanks a lot for this project !  :)

oz2cpu:
i ordered my PCB's from JLC and asked for 1.6mm
i also asked for enig, just the cheapes is fine for me,
do you expect to pull it in/out 3 times pr week, the whole year ?
then order the thicker gold :-)

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod