Products > Test Equipment

DIY Logic Analyzer Probe and Pods for Siglent (and LeCroy) scopes

<< < (40/51) > >>

Wahyueko:
yes I've tried searching, I want to try to assemble this logic probe. now I have printed the pcb to the pcb manufacturing factory.

tautech:

--- Quote from: Wahyueko on January 08, 2023, 07:51:47 pm ---yes I've tried searching, I want to try to assemble this logic probe. now I have printed the pcb to the pcb manufacturing factory.

--- End quote ---
It will not fit MSO5000.

Please go here:
https://www.eevblog.com/forum/testgear/low-cost-logic-analyzer-probe-for-rigol-mso5000-easyeda-project/

Wahyueko:
Big thanks sir,
I used the Tektronix mso5204 logic probe which is compatible with p6616, but the price is quite expensive.
not rigol mso5000

Wahyueko:
I have already printed the PCB, I hope you can, sir.

rogersstuart:

--- Quote from: Wahyueko on January 09, 2023, 09:33:48 pm ---I have already printed the PCB, I hope you can, sir.

--- End quote ---

Did you make it 2 layers without adding a ground pour? If so, you would need to reorder them anyway. The probe in this thread is not designed for the MSO5000. The Siglent scopes have all of the digital probe active electronics inside the scope. The MSO5000 series needs (at the bare minimum) external LVDS line drivers to work properly. Get on chat with JLCPCB and see if they can dispose of the PCBs you ordered and refund your shipping. There are multiple people on eBay selling the MSO5000 probes. Just go order one of those.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod