Products > Test Equipment
DMMCheck Plus Multimeter Reference(and other References) - Experiences..
<< < (21/38) > >>
bdunham7:

--- Quote from: alm on July 11, 2023, 08:47:32 pm ---
--- Quote from: Martin72 on July 11, 2023, 08:14:00 pm ---At the moment my SDS2504HD measure the same signal - without "deforming"...
Must investigate this.

--- End quote ---
The SDS1104X-E was not set to AC coupling, was it?

--- End quote ---

I think this is a known issue with the scope at low frequencies.

Here's 100Hz 10Vp-p from SDG2042X direct to SDS 1104X-E with settings as shown.

Domitronic:

--- Quote from: bdunham7 on July 11, 2023, 09:01:57 pm ---
I think this is a known issue with the scope at low frequencies.


--- End quote ---

Yes, at least my SDS1104X-E has the same issue:

https://www.eevblog.com/forum/testgear/siglent-sds1204x-e-released-for-domestic-markets-in-china/msg4433131/#msg4433131

Others reported the same in this thread.
Martin72:
Yepp, it must be an issue - connect the signal directly without a probe to the scope, no changes.
Hmm..Not so nice for SDS1104X-E owner.

Veteran68:

--- Quote from: Fungus on July 10, 2023, 03:03:08 am ---
--- Quote from: Veteran68 on July 10, 2023, 02:45:00 am ---I'm shocked, SHOCKED!, I tell you!  :D

I knew when I got it that there was no way they were typing up, printing, and cutting out each of these for each unit. The handwritten ones are much more believable.

--- End quote ---

The date on it should be a giveaway. When did you buy yours?

--- End quote ---
Had to search email history to figure out where and when I bought it.

EBay, Feb 2020. So yeah it came with 5yo cal sheet from some other device (if not entirely made up numbers to begin with).

I had bought a few different varieties of these cheap ones, like the other ones pictured in this thread, but this one was an odd duck with its battery requirement so after I was done playing with it, it went into a drawer and was never used again.

Since then I bought a LB02A process calibrator which is handier and more fun to use, and is really all the reference I need for my hobby purposes.
Martin72:
Now the SDS2504X-HD...
You musn“t buy this to get the nice histograms, you could have them with a unlikely more cheaper SDS2000X-Plus.
But the accourate DVM, you get it only with the 12bit model.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod