Products > Test Equipment
DMMCheck Plus Multimeter Reference(and other References) - Experiences..
mwb1100:
--- Quote from: Veteran68 on September 05, 2023, 12:41:39 pm ---I didn't see where they actually say anything about the new model on their site.
--- End quote ---
There was some period of time (around July 10 it seems) where the website's banner teased a new product in the pipeline. No details given, but @KungFuJosh got a few via email.
Veteran68:
--- Quote from: mwb1100 on September 05, 2023, 03:59:14 pm ---
--- Quote from: Veteran68 on September 05, 2023, 12:41:39 pm ---I didn't see where they actually say anything about the new model on their site.
--- End quote ---
There was some period of time (around July 10 it seems) where the website's banner teased a new product in the pipeline. No details given, but @KungFuJosh got a few via email.
--- End quote ---
Yeah, the banner has been saying for some time that pre-orders for new boards would begin Sept 1. On Sept 1 I sent them a message through their contact form asking for details. I haven't got a response yet (it was a holiday weekend here in the states), then when I saw the banner had changed to now accepting orders, I placed mine. Other than all options now included there's no mention of improvements or other details.
Martin72:
Hi,
I will send the device for a new calibration, calibration is done according to ISO*.
The L/C option will also be calibrated.
I was sent a sample calibration certificate, so the protocol will look like afterwards.
But I still wonder, should I send it away with the soldered leads, or not - And ask instead, with which test leads / clips they have performed the calibration, to then measure with later with the same...
*(Calibration according to DakkS is also possible, costs 30€ more)
J-R:
I'm curious, did you solder the wires to the turret terminals, or remove the turrets and solder the wires to the PCB? And which ones were modified?
Martin72:
Hi,
To the turrets and then voltage/current.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version