| Products > Test Equipment |
| Do you recognize this connector? Chauvin Arnaux E14 Current probe |
| (1/2) > >> |
| diegoperez:
After searching for a while, I could not find any information about this current probe. It is very similar to the ubiquitous chauvin arnoux E3N current probe, which I think is rebadged under various other brand names. But this one does not have the dc-offset trim pot nor the over-range led indicator. In addition, I think this current probe needs a terminating resistor at the connector end, because the gain seems to be wrong when connected to a 1-MOhm scope input impedance. Any info regarding the connector or the probe will be welcomed. Thanks, Diego |
| 0xfede:
Hi Diego, it seems to me a lemo connector. Have a look to their site: https://www.lemo.com/en Best, 0xfede |
| vtp:
Try Hypertronics D-series, possibly D02. |
| diegoperez:
--- Quote from: vtp on February 25, 2018, 09:41:10 am ---Try Hypertronics D-series, possibly D02. --- End quote --- Wow, that's right. It's a D01 series with 3 contacts (but only two are populated). After comparing the dimensions whith the catalogue, I also noticed a 'D01' engraving mark in the connector :-[ , which further confirms it. Thank you! :) |
| angeeinstein:
Did you get this probe to work? |
| Navigation |
| Message Index |
| Next page |