Products > Test Equipment

Do you recognize this connector? Chauvin Arnaux E14 Current probe

(1/2) > >>

diegoperez:
After searching for a while, I could not find any information about this current probe.

It is very similar to the ubiquitous chauvin arnoux E3N current probe, which I think is rebadged under various other brand names.
But this one does not have the dc-offset trim pot nor the over-range led indicator. In addition, I think this current probe needs a terminating resistor at the connector end, because the gain seems to be wrong when connected to a 1-MOhm scope input impedance.

Any info regarding the connector or the probe will be welcomed.

Thanks,

Diego

0xfede:
Hi Diego,

it seems to me a lemo connector.
Have a look to their site:
https://www.lemo.com/en

Best,
0xfede

vtp:
Try Hypertronics D-series, possibly D02.

diegoperez:

--- Quote from: vtp on February 25, 2018, 09:41:10 am ---Try Hypertronics D-series, possibly D02.


--- End quote ---

Wow, that's right. It's a D01 series with 3 contacts (but only two are populated).
After comparing the dimensions whith the catalogue, I also noticed a 'D01' engraving mark in the connector  :-[ , which further confirms it.

Thank you!  :)

angeeinstein:
Did you get this probe to work?

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod