Products > Test Equipment

Does anybody use Fluke Connect software?

(1/2) > >>

BeBuLamar:
I've been using Fluke Connect to do some plotting and I have strange result. Anybody have any experience with this?

EC8010:
I used it years ago to get measurements out of pair of Fluke 189 meters. I didn't like it at all and discovered that the slightest little slip would delete all the data in the meter. If I were you, I'd use the software to extract the data, immediately generate a csv file, save it, then import that into the spreadsheet of your choice for plotting.

HKJ:
To extract data you can also use TestController, it has build in plotting and can save to csv files.

EEVBlog thread about it: https://www.eevblog.com/forum/testgear/program-that-can-log-from-many-multimeters/
Download link (At the bottom of the page): https://lygte-info.dk/project/TestControllerIntro%20UK.html

BeBuLamar:

--- Quote from: EC8010 on December 25, 2024, 09:16:52 am ---I used it years ago to get measurements out of pair of Fluke 189 meters. I didn't like it at all and discovered that the slightest little slip would delete all the data in the meter. If I were you, I'd use the software to extract the data, immediately generate a csv file, save it, then import that into the spreadsheet of your choice for plotting.

--- End quote ---

The data is not saved in the meter and I am not talking about the Flukeview software. I am talking about the Fluke Connect software that run on Android and IOS. Via the serial interface the Fluke only does the most 1 reading per second. I need faster than that.

bdunham7:
I have Fluke Connect and the IR3000FC and have used it occasionally.  I don't recall it plotting points all that fast although I wasn't needing speed in that case.  What meter and what are you doing?  I can try the same thing on mine if you want.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod